Creating Custom Draperies can be challenging for drapery workrooms, especially when the designer gives you a sketch they did on a piece of paper that‘s not to scale. At Precision Draperies, that’s pretty common, and probably is for you too!
Usually, workrooms quote the job based on unknown fabrics - meaning the workroom does not see them, and the designer has no idea what they are, but has an idea of what they’re after. It’s just one of many challenges a workroom faces.
Pictures work well for drapery workrooms (as pictures are like 1000 words) to help with the design and pricing of treatments from the start.
When our designer sketched the design on a piece of paper, the design was simple, with an angled-top inverted soft-pleat drapery (D-061) with solid 36” banding along the top, with a print fabric for the main fabric, and tied back. At first glace, it looked simple, but there were a few twists in the project.
When we received the fabric for the banding, it was a striped fabric. Originally it was 54” 0 repeat fabric (rpt). The stripes were running railroaded. (Stripes ran vertical from selvage to selvage).
With the stripe running railroaded, we now had to make the banding 26” (NOT 36”) due to allowances for seaming and the angled top. This now affected the main fabric’s cut length, and also the fabric allowances for the banding. Good news - There was enough fabric on both the banding and main fabric!
Anytime you design angled-top draperies (curtains), you MUST angle the top of the drapery to same degree as the hardware (medallions or rod) installed, in order for the drapery to hang correctly. This applies to any banding along the top edge, if the banding is to follow the degree of the hardware. That’s where it can be labor and mind-challenging to put all the pieces together correctly.
That’s where we used Precision Draperies Education’s (PDE) Full-Scale Pattern Service to create the perfect pattern for all the cuts of the banding, spaces of the pleats and the cut lengths for all.
With all the on-the-job spec’s, PDE was able to create a pattern for the drapery workroom, so that they could apply the correct angle to the banding fabric, and also to
the main fabric & lining. (Diagram is very faded!)
Since the stripe fabric was only 54” wide, and to keep the stripes vertical without any additional seaming, we kept the pattern vertical, along with the stripes, causing the banding to be reduced to 26,” due to the trim-off allowances.
This is a great example of the challenges drapery workrooms face when they’re not kept up to date with project changes. Sometimes, depending on the designer, it’s not an issue if the banding size changes.
On the other hand, it could become an issue, if the client insists on a 36” band. In either case, It's best that the designers inform the drapery workroom of any changes in fabric content, width changes. stripe details etc.
Check back later for the final project!
TIP: Bookmark this page for further updates!